西南石油大学学报(自然科学版) ›› 2026, Vol. 48 ›› Issue (5): 124-134.DOI: 10.11885/j.issn.1674-5086.2025.04.07.01

• 石油与天然气工程 • 上一篇    下一篇

水平井井身结构对全井筒内气液携砂流动特性的影响

万华旭, 张宇豪, 赵昆鹏, 白博峰   

  1. 西安交通大学动力工程多相流国家重点实验室, 陕西 西安 710049
  • 收稿日期:2025-04-07 发布日期:2026-11-03
  • 通讯作者: 白博峰,E-mail: bfbai@mail.xjtu.edu.cn
  • 作者简介:万华旭,1995年生,男,汉族,甘肃庆阳人,博士研究生,主要从事多相流强化携液携砂(煤粉)研究工作。E-mail: hxwan@stu.xjtu.edu.cn
    张宇豪,1994年生,男,汉族,四川广汉人,博士研究生,主要从事多相流强化携液研究工作。E-mail:zyh@stu.xjtu.edu.cn
    赵昆鹏,1989年生,男,汉族,陕西西安人,副教授,博士,主要从事多相流动与传热等方向研究工作。E-mail: kunpeng_zhao@xjtu.edu.cn
    白博峰,1971年生,男,汉族,河北沧州人,教授,博士研究生导师,主要从事多相流动与传热等方向研究工作。E-mail: bfbai@mail.xjtu.edu.cn
  • 基金资助:
    国家科技重大专项(2025ZD1408001);国家自然科学基金(52206208);陕西省“三秦学者”创国家一流团队资助项目(2023STD03)

Influence of Horizontal Well Structure on Gas-liquid Sand-carrying Flow in the Whole Wellbore

WAN Huaxu, ZHANG Yuhao, ZHAO Kunpeng, BAI Bofeng   

  1. State Key Laboratory of Multiphase Flow in Power Engineering, Xi'an Jiaotong University, Xi'an, Shaanxi 710049, China
  • Received:2025-04-07 Published:2026-11-03

摘要: 页岩气水平井大体积压裂后出砂易致井筒砂堵,研究气液携砂多相流动特性对防砂控砂至关重要。基于实际气井,构建了包含射孔段、水平段、斜井段(增斜、稳斜、降斜)及直井段的全井筒结构,采用欧拉多相流模型数值研究了气-液-砂三相流动特性,并主要分析井身结构的影响规律,结果表明:气液携砂本质是气携液、液携砂,水平段及斜井段形成间断砂丘或砂床,径向方向依次出现高速携砂、砂床表层砂砾移动、移动砂床和静止砂床现象;直井段砂分布均匀且有回流。斜井段积砂源于管壁剪切及直井段砂回流,其砂含率最大、静止砂床最厚、砂运移速度最小,为井筒内积砂最严重位置。水平段与斜井段越长携砂越困难;小管柱可提高流速有利于携砂。井筒内增斜段最可能砂堵,且狗腿度越大风险越高。研究为页岩气水平井钻井、防砂解堵及提高采收率提供理论支持。

关键词: 气液携砂, 水平井, 页岩气, 数值模拟, 井身结构, 气-液-砂三相流

Abstract: Sand production after large-volume fracturing in shale gas horizontal wells can easily cause wellbore sand plugging, making the study of gas-liquid-sand multiphase flow characteristics essential for sand control. Based on an actual gas well, a full wellbore configuration incorporating the perforated interval, horizontal section, deviated section (comprising build-up, hold, and drop-off segments), and vertical section was constructed, and the gas-liquid-sand three-phase flow was numerically investigated using the Eulerian multiphase model, focusing on the influence of wellbore geometry. The results show that sand transport is inherently driven by gas carrying liquid and liquid carrying sand. Intermittent sand dunes or sand beds form in the horizontal and deviated sections, and in the radial direction, high-velocity sand transport, movement of sand grains on the bed surface, a moving sand bed, and a stationary sand bed appear successively. In the vertical section, the sand distribution becomes uniform and backflow occurs. Sand accumulation in the deviated section originates from the stationary sand bed induced by wall shear and sand backflow from the vertical section; it exhibits the highest sand holdup, the thickest stationary sand bed, and the lowest sand transport velocity, making it the most severe sand deposition region in the wellbore. Longer horizontal and deviated sections make sand transport more difficult, whereas a smaller tubing string enhances the flow velocity and favors sand transport. The build-up section is the most likely location for sand plugging, and the risk increases with higher dogleg severity. This study provides theoretical support for drilling, sand control and plug removal, and enhanced recovery in shale gas horizontal wells.

Key words: gas-liquid sand carrying, horizontal well, shale gas, numerical simulation, well structure, gas-liquid-sand three-phase flow

中图分类号: