西南石油大学学报(自然科学版) ›› 2024, Vol. 46 ›› Issue (4): 38-50.DOI: 10.11885/j.issn.1674-5086.2024.04.17.03

• 深层超深层油气勘探开发专刊 • 上一篇    下一篇

基于测井修正的TTI伪弹性波逆时偏移优化方法

曾庆才1, 王清华2, 曾同生1, 陈胜1, 张凯3   

  1. 1. 中国石油勘探开发研究院油气地球物理研究所, 北京 海淀 100083;
    2. 中国石油塔里木油田公司, 新疆 库尔勒 841000;
    3. 中国石油大学(华东)地球科学与技术学院, 山东 青岛 266580
  • 收稿日期:2024-04-17 发布日期:2024-08-24
  • 作者简介:曾庆才, 1969 年生,男,汉族,江西兴国人,高级工程师,博士,主要从事物探资料分析、处理和解释等方面的研究工作。 E-mail: zqc-69@petrochina.com.cn
    王清华, 1968 年生,男,汉族,湖北潜江人,教授级高级工程师,博士,主要从事塔里木叠合复合盆地的油气勘探开发研究工作。 E-mail:wqh-tlm@petrochina.com.cn
    曾同生, 1985 年生,男,汉族,江西兴国人,高级工程师,硕士,主要从事地震成像处理技术方面的研究工作。 E-mail: zengtongsheng@petrochina.com.cn
    陈胜, 1985 年生,男,汉族,湖北竹山人,高级工程师,博士,主要从事物探资料综合解释、储层预测、非常规地球物理及物探技术发展战略方面的研究工作。 E-mail:cs69@petrochina.com.cn
    张凯, 1978 年生,男,汉族,黑龙江安达人,副教授,博士研究生导师,主要从事地震波传播与成像等方面的研究工作。 E-mail:20080057@upc.edu.cn

Optimization of Pseudo Elastic Wave Reverse Time Migration with Logging Correction in TTI Media

ZENG Qingcai1, WANG Qinghua2, ZENG Tongsheng1, CHEN Sheng1, ZHANG Kai3   

  1. 1. Institute of Oil and Gas Geophysics, PetroChina Research Institute of Petroleum Exploration & Developmen, Haidian, Beijing 100083, China;
    2. Tarim Oilfield Company, PetroChina, Korla, Xinjiang 841000, China;
    3. School of Geoscience, China University of Petroleum (East China), Qingdao, Shandong 266580, China
  • Received:2024-04-17 Published:2024-08-24
  • Contact: 曾同生,E-mail: zengtongsheng@petrochina.com.cn

摘要: 在各向异性介质中,地震波在不同传播方向上速度不同。利用各向同性波动方程不能准确描述地震波的传播,在成像时会导致深层同相轴位置不准确等问题。在TTI介质弹性波方程的基础上,一方面将横波速度设置为较小的数值并引入震源环消除伪横波假象,另一方面利用测井数据对偏移参数场进行约束与修正,以提高深层复杂构造的成像精度。逆时偏移方法在进行成像时,低频噪声会对成像产生影响。为此,以拉普拉斯滤波算子去噪为基础,通过提取角度域共成像点道集,采用分角度叠加成像压制由于参数不准确导致的强振幅低频噪声。实际数据在进行成像时计算量大,采用CPU与GPU协同运算对逆时偏移进行加速以提高计算效率。模型和实际资料处理结果表明,基于测井数据约束的TTI介质逆时偏移方法能够对深层复杂构造目标区域进行准确成像,证明了方法的可行性。

关键词: TTI介质, 逆时偏移, 伪弹性波, 测井数据, 角度域共成像点道集, 分角度成像

Abstract: In anisotropic media, seismic waves have different velocities in different propagation directions. The use of isotropic wave equations cannot accurately describe the propagation of seismic waves, which can lead to inaccurate positioning of deep events during imaging. On the basis of the TTI medium elastic wave equation, this paper sets the shear wave velocity to a smaller value and introduces a source loop to eliminate pseudo shear wave artifacts. On the other hand, logging data is used to constrain and correct the parameters field, in order to improve the imaging accuracy of deep and complex structures. The reverse time migration(RTM) method can have an impact on imaging due to low-frequency noise. Therefore, based on the Laplacian filtering operator for denoising, the paper extracts the angle domain common imaging point gathers(ADCIGs) and uses angle-selected stacking imaging to suppress strong amplitude low-frequency noise caused by inaccurate migration parameters. The real data requires a large amount of computation during imaging. In this article, the CPU/GPU cooperative operations are used to accelerate migration and improve computational efficiency. The model and real data results show that the TTI-RTM method based on logging data constraints can accurately image deep and complex structural target areas, which also proves the feasibility of the method.

Key words: TTI media, RTM, pseudo elastic wave, logging data, ADCIGs, angle-selected stack imaging

中图分类号: