微米级滑石粉补强丁腈橡胶的性能研究

西南石油大学学报(自然科学版) ›› 2012, Vol. 34 ›› Issue (2): 156-160.

微米级滑石粉补强丁腈橡胶的性能研究

王煦，吴金花，舒博钊，邱岳峰

西南石油大学材料科学与工程学院，四川成都610500

收稿日期:1900-01-01 修回日期:1900-01-01 出版日期:2012-04-01 发布日期:2012-04-01

Performance of Nitrile Rubber Filled with Micro-talc Powder

Wang xu, Wu Jinhua, Shu Bozhao, Qiu Yuefeng

School of Materials Science and Engineering，Southwest Petroleum University，Chengdu，Sichuan 610500，China

Received:1900-01-01 Revised:1900-01-01 Online:2012-04-01 Published:2012-04-01

摘要/Abstract

摘要： 为使滑石粉补强丁腈橡胶（NBR），研究了滑石粉的粒径、用量和表面经偶联剂处理时对NBR 硫化胶的力学
性能影响。结果表明：滑石粉在粒径很小、用量适中时才显示较好的补强效果，2 500 目、60 份时橡胶的拉伸强度为
13.5 MPa、撕裂强度41.4 kN/m；用质量分数为1% 的KH550 处理滑石粉，橡胶的综合性能获得进一步提高，其拉伸强
度可达14.1 MPa、撕裂强度48.1 kN/m，SEM 分析指出这与偶联剂改善了滑石粉在NBR 中的分散性及相容性有关。

关键词: 粉体, 滑石粉, 丁腈橡胶, 补强, 力学性能

Abstract: In order to reinforce the nitrile rubber（NBR）with the micro-talc powder，the effects of the particle size and the
content and the surface treatment by the silane coupling agent of the talc on the mechanical properties of NBR are studied in
this paper. It is shown that the talc has better reinforcement results when its particle size is very small with its optimal content
and NBR has the tensile strength of 13.5 MPa and the tearing strength of 41.4 kN/m when the talc has the particle size of 2500
mesh and the content of 60phr，and that the comprehensive properties of NBR can be further raised with the tearing strength of
14.1 MPa and the tearing strength of 48.1kN/m when the surface of the talc is treated by 1%（mass concentration）KH550，and
that the dispersivity and compatibility improved by KH550 between the talc and NBR have been verified through the SEM.

Key words: powder, talc powder, nitrile rubber, reinforcement, mechanical properties

王煦;吴金花;舒博钊;邱岳峰. 微米级滑石粉补强丁腈橡胶的性能研究[J]. 西南石油大学学报(自然科学版), 2012, 34(2): 156-160.

Wang xu;Wu Jinhua;Shu Bozhao;Qiu Yuefeng. Performance of Nitrile Rubber Filled with Micro-talc Powder[J]. 西南石油大学学报(自然科学版), 2012, 34(2): 156-160.

[1]	程小伟, 张高寅, 马志超, 李斌, 辜涛. 页岩气水平井油井水泥的原位增韧技术研究[J]. 西南石油大学学报(自然科学版), 2019, 41(6): 68-74.
[2]	石立华, 党海龙, 康胜松, 王维波, 王强. 注入压力对CO₂驱气窜影响规律及裂缝封堵研究[J]. 西南石油大学学报(自然科学版), 2018, 40(1): 149-156.
[3]	李东洋;王垒超;张涛;王钱钱. 气体钻井中钻柱力学性能及冲蚀实验研究[J]. 西南石油大学学报(自然科学版), 2012, 34(4): 158-164.
[4]	伍开松袁新生张元翟志茂古剑飞. 合理选择丁腈橡胶胶筒本构模型探讨[J]. 西南石油大学学报(自然科学版), 2007, 29(5): 141-144.