Loading...
Office Online
Journal Online

Table of Content

    20 February 1990, Volume 12 Issue 1
    Previous Issue    Next Issue
    论文
    STUDY OF PERMIAN TO LOWER TRIASSIC DEPOSITIONAL SYSTEMS IN PINGGUO AREA, GUANXI
    Luo Qiang Hou Fanghao
    1990, 12(1):  1-8.  DOI: 10.3863/j.issn.1000-2634.1990.01.001
    Asbtract ( 1222 )   PDF (1040KB) ( 706 )  
    Related Articles | Metrics
    Permian to lower Triassic isolated carbonate platform depositional systems in Pingguo area is studed in detail in this thesis. Permian sedimentary facies of Pingguo ancient carbonate platform can be divided into carbonate platform center facies; platform margin facies and platform slop-trough facies, and lower Triassic sedimentary facies can be divided into carbonate platform facies area and classic trough facies area. Petrological and paleobiological characteristics of these facies are described and the original of various scdiments is analysed.Some problems about their distribution,tectonic control and sedimentation are discussed.According to the viewpoint of system theory,the difference between platform facies and trough facies,and the influence among them are summerized,and their evolution model is found in this paper.
    FLUID CHARACTERISTICS OF KEKEYA CONDENSATE FIELD
    Qiu Zongtian Zhang Xinglin
    1990, 12(1):  9-21.  DOI: 10.3863/j.issn.1000-2634.1990.01.002
    Asbtract ( 811 )   PDF (640KB) ( 613 )  
    Related Articles | Metrics

    This paper has clarified the surface fluid characteristics and main longitudinal physicochemical properties of five reservoirs in Kekeya condensate field, and studied, by using the data of high pressure physical properties, the changes and controlled factors of main parameters of oil, gas and water under the stratum condition in W4~2-W5 capital gas reservoirs being developed at present, and its facies state properties of underground fluids.

    DRAWING AND APPLICATION OF THE THREE-PARAMETER ROSE DIAGRAM OF JOINT
    Geng Wenzhi
    1990, 12(1):  22-35.  DOI: 10.3863/j.issn.1000-2634.1990.01.003
    Asbtract ( 1276 )   PDF (413KB) ( 828 )  
    Related Articles | Metrics
    This paper has dissected serious shortcomings of two-parameter (stripes and strikes) rose diagram in common use, presented the measure of joint growth level by joint contribution, and plotted the rose diagram with three parameters of stripes, dimensions and strikes of she joint. The set of the rose diagram directly shows the joint growth in many sides. It is very convenient to use and analyse. Its effect is very remakable.
    QUANTITATIVE ANALYSIS OF MINERAL COMPONENTS OF ROCK AND MOTES IN FORMATION BY X-RAY DIFFRACTION
    Shen Showwen
    1990, 12(1):  29-36.  DOI: 10.3863/j.issn.1000-2634.1990.01.004
    Asbtract ( 864 )   PDF (468KB) ( 614 )  
    Related Articles | Metrics
    This paper introduces a quantitative analysis method of mineral components of rock and motes in formation by x-ray diffraction. The principle of the analysis is based on intra-standard and extrastandard equations. The strength factors of minerals are determined in author s experiments. The analysis is simple and feasible, and its accuracy can demand the needs of petrology study and core analysis.
    HOW TO RECOGNIZE AND CALCULATE KICK TOLERANCE
    Liu Kai
    1990, 12(1):  37-45.  DOI: 10.3863/j.issn.1000-2634.1990.01.005
    Asbtract ( 1121 )   PDF (317KB) ( 838 )  
    Related Articles | Metrics
    This paper has presented a new definition of kick tolerance and unified it with the critical pit gain, allowable pressure of BOP and fracture pressure of bore hole, and thus given the calculation methods and formulas of kick tolerance under conditions of using shut-in wethod etc. systematically. The new definition and its calculation methods are very convenient for drilling engineers to use in the field.
    ANALYSIS OF GEOMETRIC SIZE CALCULATION OF HORIZONTAL FRACTURESDURING FOAM FRACTURING
    Xiong Youming
    1990, 12(1):  46-51.  DOI: 10.3863/j.issn.1000-2634.1990.01.006
    Asbtract ( 972 )   PDF (305KB) ( 718 )  
    Related Articles | Metrics
    In this paper, a set of numerical calculation methods for the geometric size of the horizontal fracture during foam fracturing is provided according to three kinds of typical foam fracture fluids. The effect of several parameters on the geometric size of the horizontal fracture is analysed with the orthogonal test principle. The results obtained are useful for the foam fracturing design.
    FERROGRAPHY MONITOR FOR THE BED TEST OF MUD PUMP IN LABORATORY
    Yang Qiming Zhang Benkui Peng Shengshang
    1990, 12(1):  52-62.  DOI: 10.3863/j.issn.1000-2634.1990.01.007
    Asbtract ( 749 )   PDF (1218KB) ( 634 )  
    Related Articles | Metrics
    During the monitoring of the bed test life of mud pump pistons the quantitative technique of ferrography is used to trace, photograph and analyse the formation and changes of wear debris by means of SEM and EDAX. In the meantime, the coverage of wear particles on the ferrography section is measured in due time,anda lot of data are obtained. From a serics of the information, some wear curves related to the ferrography monitoring are drawn. Combining with the occurance of charateristic metallic wear debris and the analysis of rubber debris produced,this technique provides the reliable diagnosis criteria for the failure of the test pistons.
    OPTIMIZATION DESIGN OF PARAMETERS OF SUSPENDED-PIPE BRIDGE STRUCTURE WISH CRACKS
    Zhang Peng Xiao Fangcun
    1990, 12(1):  63-68.  DOI: 10.3863/j.issn.1000-2634.1990.01.008
    Asbtract ( 949 )   PDF (342KB) ( 623 )  
    Related Articles | Metrics
    Based on the accurate calculation model of a suspended-pipe bridge(1) the optimization model in which a complete structure is made minimum is established in the article. The moddel is solved by discrete complex optimal method——MDCP, and the optimization design of a suspendedpipe bridge with cracks is completed.
    APPLICATION OF THEORETICAL CALCULATION METHOD TO OILGAS PIPELINES
    Yong Qidong Xiao Fangchun
    1990, 12(1):  69-74.  DOI: 10.3863/j.issn.1000-2634.1990.01.009
    Asbtract ( 648 )   PDF (272KB) ( 656 )  
    Related Articles | Metrics
    The theoretical calculation method is applied to pipelines in this paper The function-cost equation in oil and natural gas pipelines is deduced. According to practice, the curves of F-C are drawn. The results show that this equation is generally used for oil-gas pipelines. It is also of certain practical significance and of value for reference.
    A METHOD OF DETERMINING MULTIPLE-GOAL OPTIMAL SOLUTION BY INCIDENCE DEGREE AND HAMMING DISTANCE
    Liu Xuezheng Cui Lan
    1990, 12(1):  75-85.  DOI: 10.3863/j.issn.1000-2634.1990.01.010
    Asbtract ( 1009 )   PDF (601KB) ( 646 )  
    Related Articles | Metrics
    In this paper, we use a concept of grey system incidence degree to determine the difference degree between the membership function shapes of two fuzzy subsets and use Hamming distance to determine the close degree between the two membership functions, and thus to determine the optimal solution in the efficient solutions. The step is that the ideal solutions(consisting of the single-object optimal solutions)and efficient solutions(not bad solutions)of multiple-object optimazation questions are made fuzzy to obtain the incidence degree and Hamming distance between separate fuzzy efficient solutions and fuzzy ideal solutions.In the end,optimal solution in the efficient solutions can be determined by ordering and marking.
    GREY THEORY APPLIED TO THE FORECAST OF OIL INDUSTRIAL TOTAL OUTPUT VALUES
    Xu Tao Wang Shengtao
    1990, 12(1):  86-92.  DOI: 10.3863/j.issn.1000-2634.1990.01.011
    Asbtract ( 978 )   PDF (374KB) ( 668 )  
    Related Articles | Metrics
    In this paper, we have introduced the grey theory and the model establishing method, by which the grey forecast model of industrial total output values is established, and compared the model with the econometric model. The former has higher observation value in fluctuation-range than the latter. Using the grey model, we have computed forecast values of the oil industrial total output values in 1988, 1989, 1990, 1991, etc. We ve also pointed out the limitation of the grey model and presented the methods of eliminating it.
    SOLUTION OF THE INVERSE PROBLEM FOR AN INITIAL CONDITION IN A STRING VIBRATING EQUATION
    Jiang Maoze Wu Xiaoqing
    1990, 12(1):  93-98.  DOI: 10.3863/j.issn.1000-2634.1990.01.012
    Asbtract ( 1533 )   PDF (257KB) ( 629 )  
    Related Articles | Metrics
    In Reference (1) an abstract semigroup approach is used to prove the identifiability of the initial state of one vibrating string with viscous damping at end point. It has been proved that the system isa spectral one, and that the identifiability depends completely on the measurement of the observation time interval. In this paper, the characteristic method is used directly to solve this problem of identifiability, and the obvious solution to this problem is obtained.