Loading...
Office Online
Journal Online

Table of Content

    20 February 1985, Volume 7 Issue 1
    Previous Issue    Next Issue
    论文
    THE SEDIMENTARY ENVIROMENT PATTERN AND ITS TECTONIC CONTROL OF LATE PERMIAN AGE IN NANPANJANG RIVER AREA
    Xuang Jixiang
    1985, 7(1):  1-10.  DOI: 10.3863/j.issn.1000-2634.1985.01.001
    Asbtract ( 860 )   PDF (709KB) ( 479 )  
    Related Articles | Metrics
    On the basis of analysing the development and distribution of the sedimentary facies of late Permian age and their characteristics, it is thought that the sedimentary enviroments of late Permian in Nanpangjang river area consist of continental, shore, sub-shallow sea and shatlow-bathyal ones. Correspondingly, two kinds of earbonate platforms,the bioherm and the deep-water trough facies sedimentation are developed. The above characteristics of the sedimentary sea basin are concerned with the development history of plate tectonics in the area and directly controlled by encient faulting within this area.According to the tectonic activities,some equestions have been posed which must be paid attention to in petroleum exploration.
    A NEW CALCULATION AND EXPRESSION OF GAS-OIL RESERVES
    Wu Gueying Li Shaoji
    1985, 7(1):  11-17.  DOI: 10.3863/j.issn.1000-2634.1985.01.002
    Asbtract ( 676 )   PDF (376KB) ( 342 )  
    Related Articles | Metrics
    Volume method is one of the basic methods for the calculation of gasoil reserves. However, parameters used traditionally are average values, and from large area calculation. The results obtained in this way are not accurate, and can not reflect the characteristics of nonuniform reservoirs.In this paper, we have developed a new method, unit volume method, to count gas-oil reserves, and have drawn from the results obtained,a gasoil reserve distribution map which will play a good guiding role not only in the study of non-uniformity of gas-oil strata,but in oil expioration,development and well pattern as well.
    ORIGIN AND SOURCES OF NATURAL GAS IN XIANGXI FORMATION,MID SICHUAN BASIN
    Yang Yuancong Wang Tingdong
    1985, 7(1):  18-30.  DOI: 10.3863/j.issn.1000-2634.1985.01.003
    Asbtract ( 747 )   PDF (516KB) ( 498 )  
    Related Articles | Metrics
    In this paper,we discussed the origin of natural gas in Xiangxi formation, Mid Sichuan Basin, according to the geochemical characters of gases, condensates and source rocks in the area, in which natural gas belongs to a more typical type of coal-generating gas. Having made a series of comparison between gases, condensates and source rocks, we thought that the natural gas of Xiangxi formation in the south of this area partly comes from underlying Leikoupo formation.
    THERMAL STRESS ANALYSES IN CASINGS OF THERMAL OIL RECOVERY
    Li Binyuan
    1985, 7(1):  31-41.  DOI: 10.3863/j.issn.1000-2634.1985.01.004
    Asbtract ( 703 )   PDF (588KB) ( 494 )  
    Related Articles | Metrics
    We discussed how to use the theory of thermoelasticity in the thermal stress analyses in casings of thermal oil recovery in this paper. Also, we pointed out the defects of the theory of one-dimensional thermal expansion. The formulas have been obtained in this paper which are used to compute more accurately the thermal stress in casings of thermal oil recovery.
    THE STABILITY OF EXPLICIT DIFFERENCE SCHEMES OF THE CONVECTION-DIFFUSION EQUATION
    Zhao Bihua
    1985, 7(1):  42-50.  DOI: 10.3863/j.issn.1000-2634.1985.01.005
    Asbtract ( 1473 )   PDF (365KB) ( 556 )  
    Related Articles | Metrics
    Up to now, in acid treatment design at home and abroad, it has not been taken into account how the effective mass transfer coefficient of the hydrogen ion De varies with acid concentration Co in solving the convection-diffusion equation which shows the distribution of acid concentration along a fracture.In this paper, we have not only solved this equation by means of finite differences, considering the change of De with Co, but also shown the conditions of the stability and the method.
    THE EXPERIMENTAL STUDY OF THE FRICTIONWEAR PROPERTY OF HIGH-CHROMIUM CAST IRON AND PERBUNAN RUBBER
    Zhou Xirong
    1985, 7(1):  51-62.  DOI: 10.3863/j.issn.1000-2634.1985.01.006
    Asbtract ( 675 )   PDF (701KB) ( 578 )  
    Related Articles | Metrics
    The friction-wear property of the testing ring,which is made of High-Chromium cast iron with different hardness and surface finish, rubbing against the testing block,which is made of Perbunan Rubber with different hardness, is presented in this paper. The relative curves are drawn of the friction coefficient vs sliding velocity between the ring and the block, and so are the wear curves of three groups of specimens on condition that different hardness is matched with different surface finish during each rubbing processing.
    A RESEARCH FOR OPTIMIZING MAIN-BODY PARAMETERS OF A FRONT MOUNTED BEAM-PUMPING UNIT
    Meng Kunliu
    1985, 7(1):  63-72.  DOI: 10.3863/j.issn.1000-2634.1985.01.007
    Asbtract ( 1311 )   PDF (317KB) ( 469 )  
    Related Articles | Metrics
    Starting with the analysis of the working characteristics of a front mounted beam-pumping unit, we discussed in this paper the optimization of main-body parameters of this unit according to the present theory and method of optimum design, we have proposed the design objective by reducing the maximum fluctuating value of net torgue of output shaft in the reducer, so as to determine main-body mechanism size, balance weight and offset angle of balance mass and to make rajah-body mechanism design and calculate carrying capacity for various series of pumping units.
    A STUDY OF PNEUMATIC SHALE SHAKERS
    Yang Guojun Li Peiji Zhang Minghong
    1985, 7(1):  73-81.  DOI: 10.3863/j.issn.1000-2634.1985.01.008
    Asbtract ( 1456 )   PDF (478KB) ( 519 )  
    Related Articles | Metrics
    After analysing the construction and working principles of pneumatic shale shakers and studying the dynamics on pneumatic shale shakers, the calculation formulas of pneumatic shale shakers and vibrators have been obtained by the authors. It is pointed out in the paper that the slope angle of screen surface, excitation frequency and amplitude of pneumatic shale shakers can be regulated according to actual requirements, so that a way is explored for designing a new-type shale shaker.
    THE SOLUTION FOR LIMIT LOADS OF THIN PLATES BY USING THE METHOD OF WEIGHTED RESIDUALS
    Ling Mu Tang Juncai
    1985, 7(1):  82-88.  DOI: 10.3863/j.issn.1000-2634.1985.01.009
    Asbtract ( 626 )   PDF (193KB) ( 498 )  
    Related Articles | Metrics
    This paper uses the Method of weighted Residuals for limit analysis of structure, and evaluates the limit loads of simply-supported and clamped circular plates, simply-supported square and rectangular plates.
    THE SOLUTION TO THERMO-BENDING QUESTIONS BY MWR
    Lin Minchen
    1985, 7(1):  89-95.  DOI: 10.3863/j.issn.1000-2634.1985.01.010
    Asbtract ( 869 )   PDF (287KB) ( 489 )  
    Related Articles | Metrics
    This paper has derived a new method to calculate the critical temperature T_K, which, as the temperature increases, is yielded by the thermobending phenomena in the round-longer bar under four different conditions of binding, i.e. both ends hinged, both ends fixed, one end fixed whereas the other hinged, and one end fixed whereas the other free. The collocation method of MWR(Method of Weighted Residuals ) is used to analyse and calculate in this method, with which the common formula.
    THE STUDY OF OPTICAL SYNTHETICAL PROCESSING METHOD OF ERS IMAGE
    Ma Deyan
    1985, 7(1):  96-106.  DOI: 10.3863/j.issn.1000-2634.1985.01.011
    Asbtract ( 1572 )   PDF (3887KB) ( 510 )  
    Related Articles | Metrics
    By combining coherence optics with incoherence optics, this paper presents an optical processing method, following the papery the study of coherence optics processing of geophysical prospecting record and geological section.Increases both in image contrast and in image color are completed by duplicating ERS image, filtering and grating modulation.