西南石油大学学报(自然科学版)

• 石油与天然气工程 • 上一篇    下一篇

稠油相对渗透率实验中管线死体积校正方法

高旺来1,沈德煌2,李芳芳1   

  1. 1.“石油工程”教育部重点实验室中国石油大学(北京),北京昌平102249
    2. 中国石油勘探开发研究院,北京海淀100083
  • 出版日期:2014-02-01 发布日期:2014-02-01
  • 基金资助:

    国家科技重大专项“海上稠油高效开发新技术”(2011ZX05024)。

Correction Method for the Dead Volume of Core Exit End Pipeline in
Heavy Oil Relative Permeability Experiment

Gao Wanglai1, Shen Dehuang2, Li Fangfang1   

  1. 1. MOE Key Laboratory of Petroleum Engineering,China University of Petroleum(Beijing),Changping,Beijing 102249,China
    2. Research Institute of Petroleum Exploration and Development,PetroChina,Haidian,Beijing 100083,China
  • Online:2014-02-01 Published:2014-02-01

摘要:

稠油相对渗透率曲线是稠油油藏开发动态预测过程的重要基础数据,稠油相对渗透率实验测量过程中的误差
将会给油田开发分析传递错误信息。在稠油油藏相渗实验过程中,由于实验温度高,出口端计量管线长,系统死体积
较大,死体积孔隙中水驱油规律和死体积校正方法会对实验结果产生重要影响。在常规实验管线中进行的水驱油实
验发现,死体积管线中的原油不能全部被驱替出来,且管线中存在油水两相流动过程。油水黏度越高、驱替速度越快,
则管线中的原油采出程度越低;实验过程还存在压力测量和体积计量不同步现象,产出流体体积计量滞后于压力测
量。采用简单扣除管线孔隙体积来处理死体积的常规方法会使产油量计量产生较大误差,导致实验结果偏离真实流
动情况,对此给出了相应的校正方法。

关键词: 稠油, 相对渗透率, 误差, 死体积, 校正

Abstract:

The heavy oil relative permeability curve is an important parameter in heavy oil reservoir performance prediction.
The error in the relative permeability test caused by experimental factors will result in wrong information for reservoir development
analysis. Due to the long exit end pipeline and more dead volume in the high temperature relative permeability test,the
oil-water phases flowing law in the exit end pipeline of core holder and method of dead volume calibration will have important
effect on relative permeability experimental results. The phenomenon of non-piston like displacement and pressure hysteresis
effect have been discovered based on the water flooding experiment of heavy oil in the exit end pipeline. The breakthrough
recovery and ultimate recovery factor decrease with increasing oil viscosity and water drive velocity,and the metering oil volume
is behind the data corresponding to the pressure. The conventional data correction by oil volume deducting space volume
of pipeline may lead to the deviation of experimental results from the actual flow behavior,so a new method of data calibration
is proposed.

Key words: heavy oil, relative permeability, error, dead volume, correction