西南石油大学学报(自然科学版) ›› 2006, Vol. 28 ›› Issue (3): 70-73.DOI: 10.3863/j.issn.1000-2634.2006.03.020

• 石油与天然气工程 • 上一篇    下一篇

裂缝性油藏射孔参数对油井产能的影响研究

李海涛 王永清
  

  1. (西南石油大学石油工程学院,四川成都610500)
  • 收稿日期:2005-02-21 修回日期:1900-01-01 出版日期:2006-06-20 发布日期:2006-06-20
  • 通讯作者: 李海涛

STUDY ON THE EFFECT OF PERFORATING PARAM-ETERS UPON WELL PRODUCTIVITY IN NATURAL FRACTURE RESERVOIRS

LI Hai -tao WANG Yong-qing.   

  1. (Southwest Petroleum University, Chengdu Si-chuan 610500, China)
  • Received:2005-02-21 Revised:1900-01-01 Online:2006-06-20 Published:2006-06-20
  • Contact: LI Hai -tao

摘要: 裂缝性油藏射孔参数优化设计与常规孔隙性砂岩油藏有较大的不同,裂缝的存在使得射孔完井油井的产能评价变得十分复杂。在对裂缝孔隙性油藏射孔参数与油井产能定量关系研究的有限元模拟基础上,时一组水平缝、一组垂直缝、两组垂直缝和三组直交缝情况下射孔参数时油井产能的影响进行了较为详细的讨论和分析,获得了很多有益的结论,研制了裂缝性油藏射孔参数优化设计软件,对裂缝性及裂缝孔隙性油藏的射孔参数优化设计具有重要指导作用,有利于提高油井产能。

关键词: 裂缝性油藏, 射孔, 有限元, 优化, 产能比

Abstract: The optimization-of perforating parameters for improvingwell performance in naturally fractured reservoirs is quite differ-ent from that of conventional sandstone reservoirs. The produc-tivity evaluation of perforated oil well becomes very complicated in the presence of natural fracture in reservoirs. In this paper,the effects of perforating parameters ort well productivity for dif-
ferent fracture network configurations , including one set of trans-verse fracture , one set of vertical fracture,two sets of vertical fractures and three sets of mutual perpendicular fractures, were analyzed and discussed in detail on the basis of mathematical modeling of well productivity by the finite element method. Some useful results have been obtained, and the software.of optimal
design for perforating parameters in naturally fractured reservoirs was developed. It is very nutritious to direct the operation of per-forating completion in natural fracture reservoirs and thus en-hance the well performance.

Key words: fracture reservoir, perforation, finite element, optimization productivity ratio

中图分类号: