西南石油大学学报(自然科学版) ›› 2004, Vol. 26 ›› Issue (2): 26-28.DOI: 10.3863/j.issn.1000-2634.2004.02.008

• 石油与天然气工程 • 上一篇    下一篇

井眼倾斜角和倾斜方位对裸眼完井地层出砂的影响

刘向君1 何湘清2 罗平亚2 练章华1   

  1. (1.“油气藏地质及开发工程”国家重点实验室(西南石油学院),四川 成都 610500; 2.吐哈石油指挥部钻采院)
  • 收稿日期:2003-01-20 修回日期:1900-01-01 出版日期:2004-04-20 发布日期:2004-04-20
  • 通讯作者: 刘向君

THE EFFECTS OF WELL TRAJECTORY AND AZIMUTH ON SAND PRODUCTION OF BARE WELL COMPLETION FORMATION

LIUXiang-jun HE Xiang-qin LUO Ping-ya et al.
  

  1. (State Ket Laboratory of Oil and Gas Reservoir Geology and Exploition, Southwest Petroleum Institute, Chengdu Sichuan 610500, China)
  • Received:2003-01-20 Revised:1900-01-01 Online:2004-04-20 Published:2004-04-20
  • Contact: LIUXiang-jun

摘要: 结合等效塑性应变准则定量地研究了井眼倾斜角和倾斜方位对裸眼完井砂岩油藏出砂的影响。计算结果表明,在一定的应力和地层条件下,井斜角在0~45°时,随着井斜角的增加,井壁内的塑性应变最大值和塑性区范围都不断增加,出砂的趋势增大;当井斜角在45°~90°时,随着井斜角的增加,井眼内最大塑性应变逐渐减小,出砂趋势减小。井斜角相同,但井眼倾斜方位不同的井,井壁内产生塑性变形的区域不同,塑性变形的程度也不同,从防砂的角度,井眼,尤其水平井眼应该沿原地最小水平主应力方向,或尽可能靠近最小主应力方向。

关键词: 倾斜角, 倾斜方位, 砂岩油藏, 出砂, 有限元

Abstract: The effects ofwell trajectory and azimuth on sand production of bare well completion formation have been studied quantitatively in this paper with a commercial finite element software and Equivalent Plastic Strain. The results show that both the maximal plastic strain and the plastic area increase with well angle that ranges from 0 o to 45°at given in-situ stress and formation. The sand production in-creases too. The maximal plastic strain decreases with well angle that ranges from 45°to 90°, and the sand production decreases too.The plastic zone changes with well azimuth, even though well angle is same. It is better for sand control that Well, especially horizontal well drilling should be along with in-situ horizontal stress.

Key words: well deviation, well azimuth, sand reservoir, sand production, finite element

中图分类号: