西南石油大学学报(自然科学版) ›› 2021, Vol. 43 ›› Issue (5): 42-55.DOI: 10.11885/j.issn.1674-5086.2021.02.01.03

• 非常规油气开发专刊 • 上一篇    下一篇

基于过程分析法的页岩原位含气性评价

李俊乾1, 卢双舫1, 李文镖1, 蔡建超2   

  1. 1. 中国石油大学(华东)地球科学与技术学院, 山东 青岛 266580;
    2. 中国石油大学(北京)油气资源与探测国家重点实验室, 北京 昌平 102249
  • 收稿日期:2021-02-01 发布日期:2021-11-05
  • 通讯作者: 李俊乾,E-mail:lijunqian@upc.edu.cn
  • 作者简介:李俊乾,1987年生,男,汉族,河南商丘人,副教授,主要从事非常规油气地质研究工作。E-mail:lijunqian@upc.edu.cn
    卢双舫,1962年生,男,汉族,湖北天门人,教授,博士生导师,主要从事非常规油气地质学方面的研究。E-mail:lushuangfang@upe.edu.cn
    李文镖,1996年生,男,汉族,江西上饶人,博士研究生,主要从事页岩气评价技术和同位素效应方面的研究工作。E-mail:liwenbiao1996upc@163.com
    蔡建超,1981年生,男,汉族,河南虞城人,教授,博士生导师,主要从事岩石微观输运物理和分形几何理论等方面的研究工作。E-mail:caijc2016@hotmail.com
  • 基金资助:
    国家自然科学基金(41972123,41922015)

Evaluation on In-situ Gas-bearing Characteristic of Shale Based on Process Analysis Method

LI Junqian1, LU Shuangfang1, LI Wenbiao1, CAI Jianchao2   

  1. 1. School of Geosciences, China University of Petroleum(East China), Qingdao, Shandong 266580, China;
    2. State Key Laboratory of Petroleum Resources and Prospecting, China University of Petroleum, Changping, Beijing 102249, China
  • Received:2021-02-01 Published:2021-11-05

摘要: 为了确定页岩中总含气量、吸附气/游离气含量及其比例,建立了一种新的页岩原位含气性定量评价方法,即过程分析法。该方法将钻井取芯及现场解析全过程拆分为5个阶段,依次评价不同阶段气体(吸附气、游离气)逸散量。在获取钻井取芯、储层物性、吸附/扩散、气体特性及岩芯现场解析等数据之后,使用该方法可正演计算获得全过程的气体解析量,同时获得原位总含气量、吸附气/游离气含量及其比例等数据。应用该方法对焦石坝区块JY182-6井五峰组-龙马溪组海相页岩原位含气性进行了评价。过程分析法所得总含气量是USBM直接法结果的0.8~5.4倍(平均2.0倍);两者之间的差值为-1.27~1.58 m3/t(平均0.39 m3/t),且随吸附气比例的增加而逐渐减小。吸附气含量及其比例主要受控于总有机碳含量(正相关),游离气含量受控于孔隙度(正相关)和含水饱和度(负相关),同时受黏土矿物含量的影响(弱正相关)。

关键词: 过程分析法, 原位含气量, 吸附气比例, 页岩气, 海相页岩

Abstract: In order to determine the total gas content, adsorbed/free gas contents and their ratios in shale, the process analysis method, a new quantitative method of evaluating the in-situ gas-bearing characteristic of shale was established. This method divides the whole process of drilling coring and field desorption into five stages, and evaluates the amount of gas (adsorbed and free gas) released in different stages in turn. After obtaining a series of data including drilling coring, reservoir physical property, adsorption/diffusion, gas characteristic and field analysis etc., this method can be used to obtain the gas-desorbed amount during the whole process, and obtain the in-situ total gas content, adsorbed/free gas contents and their ratios. This method is used to evaluate the gas-bearing characteristic of marine shale in the Wufeng Formation-Longmaxi Formation of Well JY182-6 in Jiaoshiba Block. Total gas content obtained with the process analysis method is 0.8~5.4 times (average 2.0 times) of the results of USBM direct method; the difference between the two methods is -1.27~1.58 m3/t (average 0.39 m3/t), and it decreases with the increasing gas-adsorbed ratio. Adsorbed gas content and its ratio are primarily controlled by total organic carbon content (positive correlation). Free gas content is controlled by porosity (positive correlation) and water saturation (negative correlation), and is affected by clay mineral content (weak positive correlation).

Key words: process analysis method, in-situ gas content, gas-adsorption ratio, shale gas, marine shale

中图分类号: